frequency on your Receiver and Transmitter units have been preset at the factory.
We recommend setting up a new frequency while installing ceiling fan instead of using initial frequency
set by factory. (Fig 1.) To avoid frequency interference from other surrounding fans
Please use a small size tool to change the setting.
Safety Precautions:
WARNING: Disconnect source fo electrical power by removing the fuse or
Switching off circuit breakers.
• Electrical wiring must meet all local and national electrical code requirements.
• Electrical source and fan must be 115/120 volts, 60 hz.
Maximum fan motor amps 1A; Maximum light watts 150W only.
1. WALL TRANSMITTER INSTALLATION
WARNING! Hook up "IN SERIES" ONLY. DO NOT CONNECT NEUTRAL SUPPLY
WIRE OF ELECTRIC CIRCUIT TO THE TRANSMITTER WALL SWITCH,
THE TRANSMITTER WALL SWITCH AND POSSIBLE FIRE COULD OCCUR.
Step 1. Remove the exisiting wall plate and switch from the wall outlet box.
Step 2. Make the electrical connections as shown in Fig. 2 If your outlet box has a
ground wire (Green or Bare Copper) connect the Wall Transmitter's ground wire to it.
Otherwise connect the Wall Transmitter's wire directly to one of the screws from the
Outlet box. Secure all wire connections with the plastic wire nuts provided.
Step 3. Carefully tuck the wire connections inside the outlet box . Used the screws
provided to secure the wall transmitter and wall plate to the outlet box. (Fig. 3)
Step 4. Select desired frequency on the front of the transmitter.
Step 5. Return power to wall transmitter.
2. CREATING A UNIQUE FREQUENCY
Step 1. Within 60 seconds of turning the receiver AC power ON. Press the transmitter's
"Stop" button, or until the fans light blinks.
Step 2. Once the receiver has detected the frequency,the down light will blink twice.
This will indicate that the receiver has learned the frequency that was previously
selected on the transmitter.
Note: While creating a unique frequency and after the AC power is on, do not press any
other button on the transmitter before pressing the "Stop" button doing so will cause
the procedure to fail.
After completing the steps above,you should be able to operate the ceiling fan and light.
If the fan is not responding to the transmitter,please turn off power to the receiver and repeat
Step 1 and 2.(There is no indication if your fan is not equipped with a light). Please proceed
to test the fan speed to verify the remote and receiver are on the same frequency.
3. OPERATING THE REMOTE CONTROL/WALL CONTROL
Restore power to ceiling fan and test he transmitter as below for proper operation:
A.1.2.3.4.5 and 6 button
These six buttons are used to set the fan speed as follows: